We are waiting for the driver installation (update) and click OK at the end: In the window that appears, specify the path where the files were unpacked (see above in section A) of the VCP driver. In the next window select Browse my computer for driver software (Specify the path to the driver manually): Press the right button on this new device (to update the driver, press on the existing one in the Pors (Com & LPT) section – Ports: If the driver is not installed, a line will appear in unknown devices. When the cable is connected, a new line will appear in the Ports (COM & LPT) section if the driver is already installed

Start – Right click on Computer (Computer) – Select Device Manager (Device Manager): We remember the path to this folderī) We connect the KKL cable to the USB connector of the computer and remember which USB connector it was plugged into! The USB device is configured for a specific USB connector, so you need to connect the cable to one connector. Unpack the downloaded archive (or run the exe file to unpack) into a specific folder. We find for the required operating system and download (For example, the Windows line and the x86 column (32-bit).įor the ch34x chip, I advise you to take the driver from the site of the ch340 / ch341 chip manufacturer:Īt the moment, the latest driver version for ch34x 3.5. In the table: Currently Supported VCP Drivers More details about installing and updating the driver (the procedure is very similar) in Win 7:Ī) Find a VCP driver for your chip on the Internet. This is a USB device driver that you plug into a computer that simulates the operation of this device on a virtual COM port (hopefully clear)). If you have not bought a cable yet, then it is better to take with an FTDI chip (ft232.)!ĭepending on the type of chip in the cable, we put a VCP driver under it. Install the appropriate VCP driver for your KKL cable.īecause KKL cable can be made on different chips (FTDI or ft232., Ch34x, …), then I recommend just disassembling the cable and looking at the type of chip in your cable (just unscrew 4 screws). VAG EEPROM Programmer 1.19g Free Download – are not suitable for reading / writing device firmware!ĭownload the VAG epprom programmer 1.19g program (version 1.19G, because only this version learned to work through the VCP driver). Vag k + can commander 1.4 With a USB connector.Ĭables like vcds / Vasya 10.6, 11.11, 12.12, 18.9, etc. KKL cable (cable working through the K-line) is suitable

Vcds 12.12 no interface found